Newton BaseDrain Drainage

Basedrain channel sits around the perimeter of the retaining walls

Newton CDM BaseDrain and CDM FloorDrain is the drainage system used most commonly within the Newton CDM System – A range of products that collectively receive water ingressing at weaknesses within the structure and then discharge the collected water to a Newton Basement Pumping System or safe drainage.

The 18mm holes drilled in both sides of the profile, as well as to the top surface, allows water from beneath the CDM Fibran XPS-500C insulation boards and within the spacer zone to enter the drainage channels more easily.

Typical Applications

• CDM BaseDrain – Drainage conduit for the perimeter of the area to be waterproofed. Is situated at the base of the wall membrane
• CDM FloorDrain – Drainage Conduit for collection of water at construction joint to the floor and to replace Basedrain at door thresholds. FloorDrain is also used to connect the perimeter BaseDrain to the sump
• CDM BaseDrain Corner – Formed 90 degree corner
• CDM BaseDrain T-Piece – Formed T for a 90-degree connection to FloorDrain from BaseDrain and for draining through engineering brick as an alternative to open perpendicular joints
• Jetting & access Point – for inspection and maintenance access to the drainage system

Product Overview

Product Code and Details

Code D1 -  CDM BaseDrain (2m lengths) A

Code D3 - CDM FloorDrain (2m lengths) B

Code D4 - CDM BaseDrain Connector

Code D5 - Flexible Jetting Eye (Used for the inspection and maintenance of the Basedrain Drainage Conduit.

Code D6 - CDM BaseDrain Corner C

Code D7 - CDM BaseDrain T-Piece D

Code D21 - Basedrain Sump Connector 1m flexihose

Code D22 - Jointing Tape (Double sided butyl sealing tape for overlapping CDM system membranes for flanged and stud-into-stud laps).

Code D23 - CDM BaseDrain Flexi Pipe per 1 Meter

Code D24 - CDM BaseDrain Adaptor,Adaption to 63mm O/D pipe  E

Code D26 - BaseDrain Inspection Port Kit, 4 Ports/ 4 End Caps/ 2m Duct

 CDM BaseDrain Inspection Port 90-degree Bend 

Code D28 - CDM Inspection Port riser x 2m length of ducting 204mm x 60mm

Code D29 - Port Finish / End Cap (for the inspection port or the inspection port bend)

Code D30 - CDM Inspection Port Riser(Allows for inspection every 12 linear metres) x 2m length of ducting 204mm x 60mm I

63mm O/D Pipe to Titan-Pro Sump, Titan Sump or safe drainage – Please call customer services for pipe codes

Customer Services (0800 7022176) for product support.

Downloads

•  Download CDM BaseDrain Data Sheet