Wykamol Anti-Lime Sealer for Concrete Treatment

Wykamol Anti-Lime Sealer – Essential Protection for Cavity Drain Systems

Wykamol Anti-Lime Sealer is a high-performance concrete treatment, specifically designed to prevent free lime leaching before installing a Wykamol Cavity Drain Membrane System. Applied to new and existing concrete surfaces, this non-hazardous, breathable sealer ensures the long-term efficiency of waterproofing systems by preventing blockages that could compromise water drainage.

Key Benefits:

✔ Prevents Free Lime Leaching – Stops solidified lime deposits from blocking drainage systems.
✔ Optimises Cavity Drain System Efficiency – Ensures free water movement, allowing it to reach sump pumps & drainage points.
✔ Extends System Longevity – Reduces maintenance frequency and prevents system failure.
✔ Breathable Formula – Does not block pores, allowing concrete to release moisture naturally.
✔ Ideal for Old & New Concrete – Suitable for existing slabs & freshly poured concrete.
✔ Highly Concentrated – Easy to transport, reducing plastic packaging waste.
✔ Simple Application – Quick and easy to use, ensuring efficient installation.
✔ Non-Hazardous & Long-Lasting – Safe to handle and provides durable protection.

Ideal Applications:

✔ Pre-Treatment for Cavity Drain Membrane Installations (ensures unobstructed water drainage)
✔ Protection of Sump & Pump Systems (prevents sediment build-up & blockages)
✔ New & Existing Concrete Floors & Walls (reduces maintenance & enhances performance)
✔ Waterproofing Preparation for Basements & Below-Ground Structures

The Wykamol Anti-Lime Sealer is an essential step in Type C waterproofing, ensuring smooth drainage, long-term system efficiency, and reduced maintenance.

USES

Concrete slabs including: floors, walls, rafts, kickers and recesses. Underpinned properties on either side of joints. Dry-packed areas after an application of a cement based tanking product such as a Tanking Slurry System.

MIXING

The product is diluted to a maximum of 9 parts water to 1 part product to provide a ready to use solution. Into a clean container or sprayer, add 16 litres of clean water. Empty the contents of the Anti-Lime Sealer into the container or sprayer. Then fill the Anti-Lime Sealer packaging with water and empty this into the container or sprayer, also.

APPLICATION

Apply a single coat using a coarse sprayer. Move methodically, from one end to the other until complete and even coverage is achieved.

CURING

The substrate should be left for a minimum of 3 hours to allow the Anti-Lime Sealer to absorb. Once substrate is touch dry it may be walked on or covered.

COVERAGE

200m²

TDS

Wykamol Anti-Lime Sealer Data Sheet